An Economic, Full-Featured, and Remote-Controllable Switch for Fluorescent Lights, Ceiling Fans, and Motors
This X10 Wall Switch can replace any standard wall switch in your home to add remote control of lights, fans, and other appliances to your existing X10 home automation system. The switch responds to on/off commands but can also transmit its own X10 address when operated locally. This is great for status or for simply controlling other devices that are sharing the same address elsewhere in the home.
Similar dimmers are up to 50 percent deeper than X10 Wall Switch. With its slim design, installation is easy, even in small junction boxes.
Easy to Install and Set Up
This switch wires in like a standard wall switch with an additional connection to a neutral wire. To set the X10 address, press & hold the Set button until it beeps and then send the X10 address from any X10-compatible transmitter.
Built with a Quieter Relay
Because X10 Wall Switch is built with a much quieter relay than most remote-control switches, it has a click that is 80 percent quieter than traditional relay switches. This allows you to control lights and other non-dimmable devices without waking up the baby, annoying other family members, or sending your cat fleeing across the room. The click of the internal relay is barely audible.
Generates Less Heat
Unlike other switches, X10 Wall Switch uses a relay to control the load. Other switches use components that absorb about two volts of power and dissipate the heat through the front of the switch. By using a relay, the switch runs cooler and full voltage gets to the load. Read more